The Volo Power Distribution Board has been engineered from the ground up to provide the highest possible performance and reliability in a small form-factor.  The Volo PDB distributes power from a battery pack to 4 ESCs, as well as providing two regulated DC outputs for powering servos, cameras, video transmitters, etc.  Batteries may range from 3S to 6S LiPo, and the battery input is reverse polarity protected. The Power also features convenient cable tie loop holes for securing your battery cables, which remove any stresses on the solder terminals when connecting or disconnecting your battery. 
The 6V and 12V switching power supplies are synchronised and interleaved, resulting in the smallest size and best possible ripple and noise performance.  There is also an extra set of filtered 12V outputs for sensitive electronics such as cameras and video transmitters. With all electronic components on the board being Industrial spec (2 classes higher than consumer electronics) and with the board having a conformal coating you can be confident that your Multirotor is in safe hands. 

General:
- 3S or 4S-6S operation (selected via solderbridge)
- Regulated 6V and 12V outputs
- Onboard 12V video power filter (Pi filter - CLC)
- LED power indicators (indicates when the 6V & 12V outputs are within regulation, within 10%)
- 4 ESC outputs
- 12V Regulator shutdown solderbridge (for 3S operation, disables the 12V regulator if required)
- Conformal coating. Protects the electronics against moisture and chemicals.

Battery input:
- Reverse polarity and overvoltage protected (Ideal diode)
- Input voltage range (3S operation): 8 - 14VDC
- Input voltage range (4S-6S operation): 14 - 26VDC
- Absolute maximum input voltage: +28VDC

ESC outputs:
- Continuous current: 32A per output
- Peak current (10 seconds/minute): 50A per output

6V output:
- Designed for RC Receivers, Flight controllers, and Servos.
- Voltage: 6.0 +/- 0.3VDC
- Continuous current: 1.5Amps
- Peak current (10 seconds/minute): 2.0Amps
- Short-circuit tolerant (10 seconds/minute)
- LED (indicates voltage is in regulation, within 10%)

12V output:
- Standard output designed to power LED’s and accessories
- Filtered output designed for cameras and video transmitters  (Pi filter - CLC)
- Voltage: 12.0 +/- 0.3VDC
- Continuous current: 0.75Amps
- Peak current (10 seconds/minute): 1.0Amps
- Short-circuit tolerant (10 seconds/minute)
- LED (indicates voltage is in regulation, within 10%)
- 3S self-resetting fuse protection

Physical:
- Dimensions: 72.4 x 36.2mm (2.85 x 1.425")
- Weight: 14g (0.5oz)

- Mounting holes 30.5mm square spacing

Environmental:
- Operating temperature range: -20 to +70C (-4 to +158F)
- Storage temperature range: -40 to +85C (-40 to +185F)

Power Distribution





Unlike other any other power distribution board on the market the VOLO Mini PDB features convenient cable tie loop through holes to secure your battery cables with a cable tie.

This prevents any stress on the solder tabs when connecting and disconnecting the your battery. 
It features 2 Oz copper plates (double the normal thickness) to support ample current flow.
Also included are 2 battery voltage outputs to connect to video gear, LED's etc...


Specs:
Board Size:  36 x 36mm
Weight: 4 Grams
Mounting Holes:  30.5mm spacing
Cable tie holes for securing battery cables
2 Voltage Outputs (Pin headers can be soldered in)